RS125 swingarm sliders


In stock

SKU: 0146 Category:


Swingarm sliders protect the swingarm, rear axle, and axle nut in a crash and slide. The most common type of swingarm slider is a combination spool/slider, but these are prone to failure. Either the relatively small bolts holding the spools on shear off or the tabs themselves tear off the swingarm when the spools hit the ground. RhinoMoto swingarm sliders fit inside the axle and are supported by the axle when impacted from straight on or from the side. The parts are CNC machined from solid polymer rod for superior strength, fit and finish. Features are machined into each part to allow them to fit over the axle and flush against the swingarm, avoiding that “skateboard wheel stuck on the end of the axle” look. This kit installs in literally minutes with only a 5mm key key. It removes just as quickly for maintenance and can be reinstalled virtually an unlimited number of times.

Kit includes 2 sliders, aluminum connecting rod, stainless steel hardware, installation instructions and 2 RhinoMoto logo stickers. 

Additional information

Weight 1 lbs
Dimensions 13 × 4 × 1.5 in


There are no reviews yet.

Be the first to review “RS125 swingarm sliders”

Your email address will not be published. Required fields are marked *